Creates a multileader
object.
Summary
A multileader object typically consists of an
arrowhead, a horizontal landing, a leader line or curve, and either
a multiline text object or a block.
Multileaders can be created arrowhead
first,
leader
landing first, or
content
first. If a multileader style has been
used, then the multileader can be created from that specified style.
List of Prompts
The following prompts
are displayed.
Arrowhead First [
leader
Landing first/
Content first/
Options]
Leader Arrowhead First
Specifies a location
for the arrowhead of the multileader object.
- Specify Leader Landing Location
-
Sets
placement of the leader landing for the new multileader object.
If
you exit the command at this point, then no text is associated with
the multileader object.
Leader Landing First
Specifies a location
for the landing line of the multileader object.
- Specify Leader Arrowhead Location
-
Sets
placement of the arrowhead for the new multileader object.
If
you exit the command at this point, then no text is associated with
the multileader line.
Content First
Specifies a location
for the text or block associated with the multileader object.
- Point Selection
-
Sets
placement for the text box for the text label associated with the
multileader object. When you finish entering your text, click OK
or click outside the text box.
If
you choose End at this point, then no landing line is associated
with the multileader object.
Options
Specifies options for
placing the multileader object.
- Leader Type
-
Specifies a straight,
spline, or no leader line.
- Leader Landing
-
Changes the distance
of the horizontal landing line
If you choose No at this
point, then no landing line is associated with the multileader object.
- Content Type
-
Specifies the type of
content that will be used for the multileader.
- Block
-
Specifies a block within
your drawing to associate with the new multileader.
- Mtext
-
Specifies that multiline
text is included with the multileader.
- Enter the multiline text.
- None
-
Specifies no content
type.
- Maxpoints
-
Specifies a maximum number
of points for the new leader line.
- Enter the maximum points
for leader line.
- None.
- First Angle
-
Constrains the angle
of the first point in the new leader line.
- Enter first angle constraint.
- None.
- Second Angle
-
Constrains the second
angle in the new leader line.
- Enter second angle constraint.
- None.
Ribbon:
Home tab
Annotation
panel
